Carrier 39G handleiding
Handleiding
Je bekijkt pagina 6 van 20
6
Fig. 9.1 Joining Bracket
6.0 SECTION JOINING INSTRUCTION
6.1 Joining between sections 25mm & 50mm (except to diffuser section)
The installation procedure for joining bracket (Pre drilled holes) are as follows:
a. Identify the correct sections which need to be joined together.
b. Make sure all proper action are taken to level the two separate sections.
c. Affix the gasket (that is supplied with the unit) along the edges of the aluminium frame that is required to be joined
together. (refer figure 1)
d. Locate the pre-drilled holes along the horizontal and vertical frame.(refer figure 1)
e. To install the correct quantity of joining bracket, refer to SECTION JOINING INSTRUCTION sticker. Start by placing
the joining bracket between the frame and insert the bolt, nut and washer set.(refer figure 2)
f. Tighten the bolt and nut until it compress the gasket and make sure there is no leakage. The purpose of gasket is to prevent
any air leakage.
Important: Use the hole for bolt proportionately
Vertical Horizontal Total
0608 12 6
0609 12 6
0711 12 6
0811 22 8
0912 23 10
0913 23 10
0914 23 10
1015 23 10
1117 23 10
1317 33 12
1418 33 12
1420 33 12
1621 34 14
1822 34 14
1825 34 14
2025 34 14
2125 44 16
2226 44 16
2230 45 18
2234 45 18
2634 45 18
THIS UNIT SIZE IS _________________
Internal Joining Bracket Qty for two section
AHU
Size
ITEM 25mm 50mm
SCREW SET 39GA509-279 39GA509-280
GASKET QR10-12-30-04 QR10-12-50-04
BRACKET 39GH539-013 39GH539-013A
Bekijk gratis de handleiding van Carrier 39G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Carrier |
| Model | 39G |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3661 MB |
