Carrier 39G handleiding
Handleiding
Je bekijkt pagina 7 van 20
7
Fig. 9.2 Joining Bracket
6.0 SECTION JOINING INSTRUCTION
6.2 Joining to Diffuser section 25mm & 50mm
The installation procedure for joining bracket (Pre drilled holes) are as follows:
a. Identify the correct sections which need to be joined together.
b. Make sure all proper action are taken to level the two separate sections.
c. Affix the gasket (that is supplied with the unit) along the edges of the aluminium frame that is required to be joined
together. (refer figure 1)
d. Locate the pre-drilled holes along the horizontal and vertical frame.(refer figure 1)
e. To install the correct quantity of joining bracket, refer to DIFFUSER SECTION JOINING INSTRUCTION sticker. Start
by placing the joining bracket between the frame and insert the bolt, nut and washer set.(refer figure 2)
f. Tighten the bolt and nut until it compress the gasket and make sure there is no leakage. The purpose of gasket is to prevent
any air leakage.
IMPORTANT use the hole for bolt proportionately
Vertical Horizontal Total
0608 1 2 6
0609 1 2 6
0711 1 2 6
0811 2 2 8
0912 2 3 10
0913 2 3 10
0914 2 3 10
1015 2 3 10
1117 2 3 10
1317 3 3 12
1418 3 3 12
1420 3 3 12
1621 3 4 14
1822 3 4 14
1825 3 4 14
2025 3 4 14
2125 4 4 16
2226 4 4 16
2230 4 5 18
2234 4 5 18
2634 4 5 18
THIS UNIT SIZE IS __________________
AHU
Size
Internal Joining Bracket Qty for two section
Bekijk gratis de handleiding van Carrier 39G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Carrier |
| Model | 39G |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3661 MB |
