Roland TMC-6 handleiding
Handleiding
Je bekijkt pagina 15 van 32
15
Example of Connections and Settings
2. Confirm which of the TD-10 and TMC-6 the pad is connected to.
When you strike the pads connected to the TD-10, the TD-10’s trigger
indicators flash.
When you strike the pads connected to the TMC-6, the TMC-6’s trigger input
indicators flash.
[TMC]
3. Select the TMC-6’s memory number.
It is a good idea to select a Memory Number 2 (with its original value) when
adding pads to the TD-10.
[TMC]
4. Set the TMC-6’s Trigger Types (p. 27).
Select the trigger input to be set, then set the trigger type.
* When a PD-7 is connected, select “ .”
* When you have a pad connected to TRIG 2, make the settings as shown below.
[TD] [TMC]
5. Match the TMC-6’s MIDI channel to the TD-10’s drum kit part’s MIDI
channel (for example, CH10). Check the TD-10’s drum kit part’s MIDI
channel setting in the MIDI settings screen ([SETUP] - [F2(MIDI)]).
[TD]
6. To make the settings that enable the pads connected to the TD-10 to
produce sounds, make the drum kit instrument settings, following the
instructions in “Chapter 3. Instrument settings” in the TD-10 Owner’s
Manual (p. 80).
Make the settings while confirming which machine the pads are connected to
by checking the trigger indicators on both the TD-10 and the TMC-6.
[TD]
7. Make the settings for producing sounds with the pads connected to the
TMC-6.
First, select the TD-10 percussion group.
Select [KIT] - [F2(FUNC)] - [F1(PRCGRP)] to call up the percussion group
settings screen, and with the left [CURSOR], move the cursor to the
percussion group’s number.
Referring to “Note Number (factory settings)” in the TD-10 Owner’s Manual
(p. 150), select a percussion group that includes the instrument you want to
play. If the instrument you want is not available, you can select the
instrument you prefer in Step 10, so at this point, select a percussion group
whose settings can be changed (for example, Group 2).
Trigger Input Trigger Type
2 (Head) Select a type according to the connected pad
2 (Rim)
You cannot prevent
crosstalk between pads
connected to the TD-10
and pads connected to the
TMC-6. Try increasing the
distance between pads, or
raise the Threshold.
In the TD-10’s drum kit
settings screen, you can
only set the instruments
that are to be played using
the pads connected to the
TD-10. Note that if you
strike one of the TMC-6’s
pads, the display still does
not change to the settings
for that pad.
Bekijk gratis de handleiding van Roland TMC-6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Roland |
| Model | TMC-6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4217 MB |
