Roland TMC-6 handleiding
Handleiding
Je bekijkt pagina 11 van 32
11
Making the Pad Settings
When initially making the settings of the TMC-6, first:
1.
Select a TRIG TYPE (Trigger Type) parameter suitable for the
connected pad.
This setting ensures that pads are correctly recognized.
2. With the MIDI CHANNEL parameter, set the MIDI channel used by the
TMC-6 for transmitting data so it matches the MIDI channel that the
external MIDI device or other equipment uses to receive data.
3. Use the MIDI Note No. parameter to specify the MIDI note number used
to produce sounds when the pads are struck.
4. Lastly, use the SENSITIVITY parameter to adjust the sensitivity of the
pad to regulate the pad response.
This is the general process used for making the pad settings.
You can save the settings made in Steps 2 and 3 to Memory Numbers 1–12
and then you can instantly change sounds and play different instruments by
selecting these memory numbers. If you are using an acoustic drum set, you
can set the memory number ““ so that no MIDI message is output, and
play only the acoustic drum sound.
Specifying a Trigger Type
■ Choosing the Pad to Edit
There are two ways you can use to select pads: striking pads to select them
(Trigger Chase ON), and selecting pads by pressing the [TRIGGER SELECT]
button (Trigger Chase OFF).
When you want to adjust the settings for multiple pads while striking them
in sequence, you should set Trigger Chase to ON. On the other hand, when
you want to adjust the settings for a single pad while checking for the overall
balance in the sound (while striking the other pad, too), set Trigger Chase to
OFF.
Striking a Pad to Select That Pad (Trigger Chase ON)
1. Press the [EDIT] button to make its indicator light.
This takes you into Edit mode.
2. If the [TRIGGER SELECT] button is lit, it indicates that Trigger Chase is
ON. If the button is not lit, hold down the button until the light comes
on.
3. Strike the pad to be set.
The trigger input indicator for the pad you’ve struck lights, indicating that
the trigger input has been selected.
By pressing the [TRIGGER
SELECT] button, you can
select trigger inputs
regardless of the Trigger
Chase settings.
Depending on the Trigger
Type settings, you cannot
select trigger inputs even if
you strike pads. Should be
the case, press the
[TRIGGER SELECT]
b
utton several times, and
select the trigger input you
want to edit.
Bekijk gratis de handleiding van Roland TMC-6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Roland |
| Model | TMC-6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4217 MB |
