JANDY JAOPX200 handleiding
Handleiding
Je bekijkt pagina 8 van 60
Page 8
ENGLISH Jandy
®
X Series
™
AOP System | Installation & Operation Manual
Section 4. Operation
4.1 Initial System Start-Up
Upon completing all of the system connections and
cleaning the pool as outlined in the section Pool
Preparation, you are ready to start the Jandy AOP
system.
1. Check electrical connections at breaker box.
2. Turn on pool circulation system and verify the
Jandy AOP system has power.
4.2 Normal Operation
Indicator Lights: The
JAOPX500
has two external
indicator lights onits left side. When the
Jandy
AOP system
has power, the power indicator will
illuminate. The flow indicator may be on momentarily.
Once adequate water is flowing, the flow indicator
will go out. If the flow indicator light is still lit
after the pumphas reached steady flow. Refer to
Troubleshooting section.
4.3 System Shut-Down
The following sequence of steps must be followed
for servicing or for storage.
1. Shut off power at the breaker.
2. Shut off water to the unit.
3. Open door.
4. Disconnect all electrical, plumbing, and
mounting connections for storage.
4.4 Winterizing
If the pool will be shutting down for the winter
months and the Jandy AOP system will remain
exposed tofreezing temperatures, the unit must
be drained to prevent freeze damage to the wetted
components. Todrain the Jandy AOP system, see
the following steps.
1. If the Jandy AOP system is mounted below the
water level, isolation valvesmust all be CLOSED
to prevent excess water from draining into the
unit.
2. Open the door.
3. Locate the drain plug (refer to Figure 7) and
remove to drain the remaining water in the
Jandy AOP system.
4. Allow all the water to drain from the Jandy AOP
system before threading the plug back into the
UVreactor.
4.5 Water Chemistry
Regular chlorine testing should be performed as
normal. Ozone will be eliminating the majority of
contaminants. Therefore, only a small amount of
chemicals will need to be added – just enough
to maintain the appropriate residual level of free
chlorine. Ozone is pH neutral and will not cause
pHor total alkalinity fluctuations.
Bekijk gratis de handleiding van JANDY JAOPX200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JANDY |
| Model | JAOPX200 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7868 MB |
