Bogen Nyquist NQ-GA20P2 handleiding
Handleiding
Je bekijkt pagina 32 van 45
28
Frequency Set the cutoff frequency. You can adjust the frequency by
moving the knob (click and move up or down) or by dou-
ble-clicking the knob and typing the frequency. When typ-
ing the frequency, only numeric values from 20 Hz to
20,000 Hz can be entered.
The high-pass filter attenuates content below this fre-
quency and lets frequencies above this cutoff frequency
pass through the filter.
Type Available filter types are:
• Linkwitz-Riley (12, 24, 36, and 48 dB per octave)
• Butterworth (6, 12, 18, 24, 30, 36, 42, and 48 dB per
octave)
• Bessel (12, 18, and 24 dB per octave)
Note: The term “dB per octave” describes how steeply frequencies
below the selected cutoff frequency are attenuated. For example, if the
cutoff frequency is 100 Hz and the filter type specifies 12 dB per
octave, a 50-Hz signal (i.e., one octave lower) will be attenuated by 12
dB and a 25-Hz signal (i.e., two octaves lower) will be attenuated by an
additional 12 dB.
Low-Pass (High Cut)
This feature helps eliminate high-frequency noise (signals of 8000 Hz and above) such
as background hiss and sibilance (excessive "S" in vocals, etc.) and is used primarily
with microphone-level input. It is particularly effective when handheld microphones
are used.
Enable Enables or disables the Low-Pass filter.
Table 11. High/Low Pass Parameters (Continued)
Bekijk gratis de handleiding van Bogen Nyquist NQ-GA20P2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bogen |
| Model | Nyquist NQ-GA20P2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5186 MB |
