Bogen Nyquist NQ-GA20P2 handleiding
Handleiding
Je bekijkt pagina 33 van 45
29
Adjusting the Limiter
A limiter is a compressor with a high slope (i.e., attack) that is used to prevent a signal
from exceeding a set decibel level. Limiters are used as safeguards against signal clipping.
Limiter parameters are set per channel.
Frequency Set the cutoff frequency. You can adjust the frequencies by
moving the knob (click and move up or down) or by dou-
ble-clicking the knob and typing the frequency. When typ-
ing the frequency, only numeric values from 20 Hz to
20,000 Hz can be entered.
The low-pass filter attenuates content above this fre-
quency and lets frequencies below this cutoff frequency
pass through the filter.
Type Available filter types are:
• Linkwitz-Riley (12, 24, 36, and 48 dB per octave)
• Butterworth (6, 12, 18, 24, 30, 36, 42, and 48 dB per
octave)
• Bessel (12, 18, and 24 dB per octave)
Note: The term “dB per octave” describes how steeply frequencies
above the selected cutoff frequency are attenuated. For example, if the
cutoff frequency is 8,000 Hz and the filter type specifies 12 dB per
octave, a 16,000-Hz signal (i.e., one octave higher) will be attenuated
by 12 dB and a 32,000-Hz signal (i.e., two octaves higher) will be atten-
uated by an additional 12 dB.
Table 11. High/Low Pass Parameters (Continued)
Bekijk gratis de handleiding van Bogen Nyquist NQ-GA20P2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bogen |
| Model | Nyquist NQ-GA20P2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5186 MB |
