Axxess AXDIS-HK1 handleiding
Handleiding
Je bekijkt pagina 5 van 12
5
REV. 9/24/24 INSTAXDIS-HK1
With the key in the off position:
• Connect the 16-pin harness with
stripped leads, and the AXDIS-HK1
harness, into the AXDIS-HK1 Interface.
• For models equipped with a factory
amplifier, connect the AXSP-HK (sold
separately) to the AXDIS-HK1 interface.
Attention!
Do not connect the AXDIS-HK1
harness to the vehicle’s wiring harness until
Step 2 of Programming.
Attention!
If retaining steering wheel
controls, ensure that the jack/wire is
connected to the radio before proceeding.
If this step is skipped, the interface will
need to be reset for the steering wheel
controls to function.
I N STALL ATI O N
Continued on the next page
LED Feedback: The (24) Red LED flashes represent a
different radio manufacturer for the AXXESS steering wheel
control interface (sold separately) to detect. For example,
if you are installing a JVC radio, the AXXESS steering
wheel control interface will flash Red (5) times, then stop.
Following is the L.E.D Feedback Legend, which indicates
the flash count of the radio manufacturer.
Flash Count
Radio
1
Eclipse (type 1) †
2
Kenwood ‡
3
Clarion (type 1) †
4
Sony / Dual
5
JVC
6
Pioneer / Jensen
7
Alpine *
8
Visteon
9
Valor
10
Clarion (type 2) †
11
Metra OE
12
Eclipse (type 2) †
Flash Count
Radio
13
LG
14
Parrot **
15
XITE
16
Philips
17
TBA
18
JBL
19
Insane
20
Magnadyne
21
Boss
22
Axxera
23
Axxerra (type 2)
24 Alpine (type 2)
LED Feedback Legend
KEYNOTES
* If the AXXESS steering wheel control interface flashes
Red (7) times, and an Alpine radio is not installed, that
means there is an open
connection not accounted for. Verify
that the 3.5mm jack is
connected to the correct steering
wheel jack/wire in the radio.
** The AX-SWC-PARROT is required (sold separately). Also,
the software in the radio must be rev. 2.1.4 or higher.
† If a Clarion or Eclipse radio is installed and the steering
wheel controls do not function, change the radio to Clarion
(type 2) or Eclipse (type 2) respectively. If the steering
wheel controls still do not function, refer to the Changing
Radio Type document available at axxessinterfaces.com.
‡ If a Kenwood radio is installed and the LED feedback
flashes (5) times instead of (2), manually change the radio
type to Kenwood. To do this, refer to the Changing Radio
Type document available at axxessinterfaces.com.
Bekijk gratis de handleiding van Axxess AXDIS-HK1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-HK1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1414 MB |
