Axxess AXDIS-HK1 handleiding
Handleiding
Je bekijkt pagina 6 van 12
6
5. The radio will shut off at this point. This process should take 5 to 30
seconds. Once the vehicle has been auto detected by the interface, the
LED will turn solid Green, and the radio will come back on, indicating
programming was successful.
6.
Turn the vehicle off then on again to make sure the programming worked.
7. Test all functions of the installation for proper operation, before
reassembling the dash.
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED
1.
Turn on the vehicle.
2. Connect the AXDIS-HK1 harness to the wiring harness in the vehicle.
3. The LED will initially turn solid Green, then turn off for several seconds,
while it auto detects the radio installed.
Note: If the vehicle is Non-Amplified, press and hold VOLUME UP while
the Green light is on solid.
4. The LED will then flash Red up to (24) times, indicating which radio is
connected to the interface, and then turn off for several seconds. The LED
will then turn solid Red, while the interface auto detects the vehicle.
O
F
F
A
C
C
O
N
S
T
A
R
T
Green & Red LED
Green or Red LED
Green & Red LED
Green LED
PROGRAMMING
Green & Red LED
Green LED
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
Bekijk gratis de handleiding van Axxess AXDIS-HK1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Axxess |
| Model | AXDIS-HK1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1414 MB |
