ZyXEL PoE12-3PD handleiding
Handleiding
Je bekijkt pagina 17 van 57
Chapter 19 Introduction
PoE12-3PD User’s Guide
10
5 Select a device and then use the icons to perform actions. Some functions may not be available for
your devices.
Note: You must know the selected device admin password before taking actions on the
device using the ZON Utility icons. If the selected device is being managed or has been
managed by the NCC, check Local credentials in the NCC's Site-wide > Configure >
Site settings screen for the selected device's current password.
Figure 18 Password Prompt
The following table describes the icons numbered from left to right in the ZON Utility screen.
Table 63 ZON Utility Icons
ICON DESCRIPTION
1 IP Configuration Change the selected device’s IP address.
2 Renew IP Address Update a DHCP-assigned dynamic IP address.
3 Reboot Device Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
4 Reset Configuration to
Default
Use this icon to reload the factory-default configuration file. This means that you will
lose all previous configurations.
5 Locator LED Use this icon to locate the selected device by causing its Locator LED to blink.
6 Web GUI Use this to access the selected device Web Configurator from your browser. You will
need a username and password to log in.
7 Firmware Upgrade Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
The ZON only supports a standalone mode AP for the firmware upgrade, it does not
support to upgrade the firmware for a managed mode AP.
8 Change Password Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
9 Configure NCC
Discovery
The option is available if the selected device supports Nebula Control Center (NCC)
discovery. You must have Internet access to use this feature. Use this icon on the
selected device to enable or disable the Nebula Control Center (NCC) discovery
feature.
If the feature is enabled, the selected device will try to connect to the NCC. If the
selected device has successfully connected to the NCC and is registered on the NCC,
it will change to the Nebula cloud mode.
Bekijk gratis de handleiding van ZyXEL PoE12-3PD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ZyXEL |
| Model | PoE12-3PD |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5949 MB |
