Zodiac Vortex-Pro VX40 handleiding

24 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 8 van 24
Figure 13. Remove Protective Cap
Figure 14. Connect Power Cable
2. Gripthenotchedendoftheoatingpower
cable, insert into the control box, and turn
clockwise to tighten. (Figure 14.)
NOTE: Toavoiddamagingthepowercable,donottryto
twisttheentIrecablehousing(seebelow).
NOTE: Toavoidexposingthepowercableconnectorpins
towater,besuretheconnectorisscrewedinallthe
wayandthereisnogap.(seebelow).
Section 4. Operation
CAUTION
Topreventdamagetothecleaner,besuretoadhere
tothefollowingguidelines:
Removethecleanerfromthepoolafterthe
cleaningcycleiscompletedandstoreonthecaddy
outofdirectsunlightorinclementweather.
Neverliftthecleaneroutofthepoolbythefloating
cable.Alwaysusetheliftfeaturetoremovecleaner
fromthepool.
Takeadditionalcarewhenliftingthecleaneroutof
thepool.Itbecomesheavierwhenfilledwithwater.
Alwaysremovethecleanerfrompoolwhensuper
chlorinatingoraddingacid.
Donothandlecleanerwhileitisinoperation.
IMPORTANT
Alwaysmakesurethecleanerheadisfully
submergedbeforeyoubeginoperation.
Cleanthefiltercanisteraftereachcleaningcycle.
Donotleaveyourcleanerinthepoolona
permanentbasis.
Attheendofeachcycle,removethecleanerfrom
thepool.Startatthecleanerheadanduntangleany
coilsinthecablebeforestoringthecleaner.
H0516700_REV A
8

Bekijk gratis de handleiding van Zodiac Vortex-Pro VX40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkZodiac
ModelVortex-Pro VX40
CategorieNiet gecategoriseerd
TaalNederlands
Grootte4454 MB