Zodiac PM40 handleiding
Handleiding
Je bekijkt pagina 16 van 31
36
2.4.4 Seng the me
• Press for 5 seconds to set the me.
The hours ash to show that they can now be changed.
• Set the hours using the or keys.
• Press to conrm the hours seng.
Once the hours have been conrmed, the minutes begin to ash.
• Set the minutes using the or keys.
• Press to conrm the minutes seng.
2.4.5 Programming "TIMER"
Up to three dierent "TIMERS" can be set for the PM40 heat pump.
Seng "TIMER" 1, 2 or 3:
• Press to set "TIMER 1".
The hours start to ash with the indicator (to set the start me).
• Set the hours using the or keys.
• Press to conrm the hours seng.
Once the hours have been conrmed, the minutes begin to ash.
• Set the minutes using the or keys.
• Press to conrm the start me seng and proceed to seng the stop me ( indicator lit).
• Repeat the same steps as above to set the stop me ( indicator lit) for the "TIMER".
• Press to conrm the sengs for "TIMER 1".
• Press then , the symbols start to ash.
• Press to set "TIMER 2" or "TIMER 3".
• Follow the same steps for seng "TIMER 1" in order to set "TIMER 2" and/or "TIMER 3".
• Jointly enabling the mers and heang priority aects the operang logic of the appliance and ltraon,
see § "2.5 I Jointly enabling the mers and heang priority".
Disabling "TIMER" 1, 2 or 3:
• Previously select the TIMER to be disabled using the key then to select "TIMER" 1, 2 or 3.
• To disable the "TIMER", set the start me and stop me for the "TIMER" to the same me by following the
steps indicated in the paragraphs for seng the "TIMER".
2.5 I Jointly enabling the mers and heang priority
• No mer is enabled on the heat pump by default: the sengs for each mer show that the start me is the same as
the stop me (see "2.4.5 Programming "TIMER"").
• The Heang priority is disabled by default. To enable it:
- Connect the lter pump, see "1.5.1 "Heang priority" opon",
- Check that seng F09 is set to 1 (Heang Priority enabled: operaon is 5-minute cycles every
2 hours to check the incoming water temperature without taking into account the pressure
sensor) and not to 0 (Heang Priority disabled: connuous operaon of the lter pump).
• As soon as the lter pump has been connected to the heat pump, operaon thereof depends on the
heat pump's lter clock (and no longer on the lter pump's mers).
• To stop this control over the lter pump, disconnect the connecons between the lter pump and the
heat pump.
EN
Bekijk gratis de handleiding van Zodiac PM40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | PM40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8785 MB |
