Zodiac Heat Line handleiding
Handleiding
Je bekijkt pagina 10 van 17
9
❸ Use
• Never run the circulang pump (depending on the model) without water. The circulang
pump is very quiet when it starts up; you may not hear it running.
3.1 I Operang principle
The heat pump uses the calories (heat) from the home's heang to heat up the pool's water.
The heat is exchanged through a series of pipes: the home's heang water circulates through the exchanger's body and
the pool water circulates through the pipes.
Tips: improve the pool's temperature rise and maintenance
• Cover the pool with a sheet (bubble canopy, canvas, etc.) to prevent heat loss. The closer the heat source
is to the exchanger, and the exchanger is to the pool, the less heat will be lost.
• Ancipate the commissioning of your pool far enough in advance before you use it.
• For the temperature rise, set the ltraon pump to connuous operaon (24/24).
• To maintain the temperature throughout the season, run "automac" circulaon for at least
12 hours/day (the longer this me the longer the appliance will have enough operang range to heat up)
3.2 I User interface presentaon (depending on the model)
Display screen (default: water temperature measured)
"On/o" buon
Value seng buons
Steady Flashing O
"On/o"
“On/o”
Appliance
powered up
/
No electrical
supply
Heang light
Heang in
progress
• Timed before operaon
• No water circulaon in the secondary
circuit (less than 1.1m³/h)
No need for
heang
Tips: using the user interface
• The temperature is regulated by degrees.
• Hold down the buons to scroll through the values quickly.
• The setpoint adjustment range is between 2° and 40°C.
• The maximum temperature may be lowered to protect the pool liner (see § 3.2.1 “Modifying the
maximum setpoint”).
3.2.1 Modifying the maximum setpoint
• Switch o the regulator (the "ON" light goes o and the pool water temperature is displayed),
• Press and simultaneously for 5 seconds: "PA" is displayed,
• Press , then enter the value "80" with or (code to access the "Sengs" menu),
• Press to conrm: "PA" is displayed,
• Press and simultaneously for 5 seconds: "/1" is displayed,
• Press to scroll through each parameter unl "r2" is displayed,
• Press , the current "r2" parameter value is displayed,
• Press or to modify the maximum setpoint value, then press to validate this new value,
• Press the and keys at the same me for 5 seconds to return to the pool water temperature display.
Bekijk gratis de handleiding van Zodiac Heat Line, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zodiac |
| Model | Heat Line |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3817 MB |
