Zipper ZI-HB254N handleiding
Handleiding
Je bekijkt pagina 34 van 44
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at 34
ZI-HB204N | ZI-HB254N
• Insert workpiece so that the surface to be machined facing up-
wards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed change
to the opposite operator side of the machine and take on the fin-
ished workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
NOTE
• In the case of resin residues on the wood, it may be advisable to apply a thin layer
of a special lubricant to the machine table in order to ensure that the workpiece
slides evenly through the thickness planer.
• If the workpiece is no longer moved by the automatic feed, pull out the workpiece
manually.
• After operation switch off the machine
• Before further activities wait until blade shaft is at a standstill!
15.8 After working process
NOTE
After the working process the planer and thicknesser must be turned off:
• Switch off the machine and disconnect the machine from the power supply.
• Adjust the planer knife cover so that the planer shaft is completely covered
16 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
WARNING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or repair
work and secure it against unintentional reconnection.
16.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe op-
eration.
NOTE
Incorrect cleaning products can attack the finish of the machine. Do not use any solvents,
nitro thinners or other cleaning products that could damage the machine's finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
• Remove chips and dirt particles from the machine after each use with a proper tool.
• Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
16.2 Maintenance
The machine is low maintenance and only a few parts require maintenance. Malfunctions or defects
that are likely to impair your safety must be rectified immediately!
• Check that the safety devices are in good condition before each operation.
• Check the connections at least once a week for a tight fit.
• Check the correct and readable status of the Machine's warning and safety labels on a re-
gular basis.
Bekijk gratis de handleiding van Zipper ZI-HB254N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-HB254N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11297 MB |
