Zipper ZI-HB254N handleiding
Handleiding
Je bekijkt pagina 33 van 44
OPERATION
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at 33
ZI-HB204N | ZI-HB254N
15.6.3 Planing short workpieces
• When planing short workpieces, a sliding wood or similar device
should be used!
• Adjust planer fence and blade guard to the size of the sliding
wood.
• Place the workpiece on top and push it slowly and evenly over the
shaft using the sliding wood.
• After use, the sliding wood must be reattached on his place on the
side of the machine.
15.6.4 Planing the workpiece with small cross section
• When planing workpieces with a small cross-section, an additional
wood angle must be mounted!
• Fasten the wood angle to the planer fence as shown using lever
clamps.
• When planing, place the workpiece on the planer table and press
it against the additional wood angle and planer table.
• Place the workpiece on top and push it slowly and evenly over the
shaft using the sliding wood.
15.7 Thicknessing
• Long, protruding workpieces must be sufficiently supported! Use suitable aids such as roller
blocks etc. for this purpose. If you do not follow these instructions, there is a danger of the
workpiece being raised up quickly and/or the machine being tilted!
• Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
• For workpieces with a difference in thickness, the chip removal must be measured at the
maximum thickness and the workpiece machined with this side first.
• Make sure that the workpiece to be machined is free of foreign objects and/or knots in order
to avoid dangerous fractures.
• Only plane workpieces that rest firmly on the machine and can be guided safely!
• If several workpieces are to be processed in series, all pieces of the same thickness should be
run through in succession without changing the setting.
• Perform the machining process from the beginning until the desired thickness is achieved.
15.7.1 Thicknessing of workpieces
working direction
• Set the required height of the thicknessing table
with the hand crank (1).
• The height will be shown on the scale (2)
• Set the thicknessing table height to the workpiece
height minus the requested cutting depth.
• Maximum cutting depth refer to the technical data!
NOTE: At the beginning of the thicknessing process,
the workpieces may still have very different thicknesses
- this must be taken into account in the set cutting
depth in order not to overload the machine.
• Switch on the machine.
Bekijk gratis de handleiding van Zipper ZI-HB254N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-HB254N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11297 MB |
