Zipper ZI-HB254N handleiding
Handleiding
Je bekijkt pagina 32 van 44
OPERATION
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at 32
ZI-HB204N | ZI-HB254N
Do not operate the machine without the dust collection system connected to it and switched on.
The dimensions of the dust collection plug can be found in the technical data.
15.6 Planing
WARNING
The unused part of the planing shaft for machining the workpiece must be covered by
the covers (planer knife cover, guidance planer fence). Never touch the edges of the
workpiece with your fingers, but always leave both hands on the workpiece with your fin-
gers when planing. If the workpiece is short and narrow, use the sliding wood.
Only plane workpieces that rest firmly on the machine and that can be guided safely!
working direction
• Fix the planer fence (1) in the desired
working position.
• Set the desired planing thickness
with the adjustment knob (3).
• Adjust the planer knife cover (2) so
that the distance between the cover
and the workpiece is approx. 5mm.
• Start machine
• Press the workpiece against the planer table with one hand.
• Push the workpiece slowly and evenly over the shaft with the sec-
ond hand.
• After finishing the operation switch off the machine.
• Wait until the shaft has come to a standstill before proceeding
with any further work!
15.6.1 Planing small workpieces
• Lower the planer knife cover (C) so that the planing shaft is cov-
ered.
• Move the planer knife cover to the workpiece and fix it with a dis-
tance of approx. 5mm.
• When planing, place the workpiece with the small side on the
planer table and press with one hand against the planer fence and
planer table.
• Push the workpiece slowly and evenly over the shaft with the sec-
ond hand.
15.6.2 Planing with tilted planer fence
• Lower the planer knife cover so that the planing shaft is covered.
• Move the planer knife cover to the workpiece and fix it with a dis-
tance of approx. 5mm.
• When planing, place the workpiece with the small side on the
planer table and press with one hand against the planer fence and
planer table.
• Push the workpiece slowly and evenly over the shaft with the sec-
ond hand.
Bekijk gratis de handleiding van Zipper ZI-HB254N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-HB254N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11297 MB |
