Zipper ZI-HB254N handleiding
Handleiding
Je bekijkt pagina 30 van 44
OPERATION
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at 30
ZI-HB204N | ZI-HB254N
14.6 Connecting to a dust collection system
The machine must be connected to a dust collection system for dust and chips. The dust collection
system must start up at the same time as the machine’s engine. The air speed at the suction connec-
tion and in the exhaust air lines must be at least 20 m/s for materials with a moisture <12 % (at least
28 m/s for moist chips with a moisture >12 %). The hoses used must be flame-retardant (DIN4102 B1)
and permanently antistatic (or earthed on both sides) and comply with the relevant safety regula-
tions. For information on air volume flow, negative pressure and suction connection, please refer to
the technical specifications.
15 OPERATION
15.1 Operating instructions
WARNING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before carrying out any modi-
fication and secure it against unintentional reconnection.
CAUTION
• Never start the machine with a workpiece pressed down!
• Long workpieces must be supported
• Property damage and injury by bouncing up the workpiece or tilting of the ma-
chine possible!
15.2 Initial check before start
• Check that all guards are installed.
• Check whether suitable planing knives have been correctly assembled.
• Check whether the connection to a dust collection system is available.
• Check whether the switching pins of the dust collector hood are plugged in correctly.
• Check that the planer shafts rotate in the correct direction.
15.3 Settings
1. Height adjustment of the planing tables
Entry planer table
The cutting depth is set with the adjustment knob
planer cutting depth (1)
Check scale knife entry planer table = 0
If necessary, adjust the arrow of the scale (2)
2. Setting arm and planer knife cover
Height
• Set the desired height with adjusting screw (5)
Planer knife cover
• Loosen the clamping screw (6)
• The planer knife cover can be moved and
adapted to the size of the workpiece
• Relock the clamping screw (6) when the desired
position is reached.
Bekijk gratis de handleiding van Zipper ZI-HB254N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-HB254N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11297 MB |
