Zipper ZI-BSF1500 handleiding
Handleiding
Je bekijkt pagina 27 van 39
OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 27
ZI-BSF1500
15.2 Information on Initial Start-up
NOTE
Note that the machine is delivered without fuel. Make sure that this equipment is
filled up before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been refilled to
the upper limit.
15.2.1 16.1.1 Test Run Initial Start-up
• Let the machine run idle for about 3 minutes.
• Pay attention to abnormal noises.
• Pay attention to the exhaust fumes (too black, too white)?
15.2.2 Notes on the first 20 operating hours
In order to optimize the life expectancy of your machine, the following points should be observed:
• Do not operate the engine for the first 20 operating hours @ maximum load (this also
applies to used engines after extensive maintenance). This means lower speed and lower
maximum working load than during normal operation.
• Change the engine oil after the first 20 hours of operation.
15.3 Checklist before commissioning
Check before start-up
• the work area and remove loose objects or objects,
• the engine oil level,
• the amount of fuel in the tank,
• whether the tank cap is tightly closed,
• the fuel lines for leaks and wear,
• whether the milling tool is firmly mounted,
• the tires for a firm fit and mobility,
• the tire pressure,
• whether the steering device is fixed,
• whether all machine covers are firmly installed.
15.4 Handling
15.4.1 Operator position
• The operator position is located at the rear of the machine
(1)
• The steering device and control lever (2) must be always
within reach during operation.
15.4.2 Start machine
1. Position the machine upright and lock the brake (1).
2. Turn the fuel shut-off valve (2) to the “On” position.
3. Also turn the engine On-Off switch (3) (ignition switch) to the
“On” position.
1
WARNING
Risk of injury from flying parts!
Loose objects (stones, roots, wires, etc.) can get caught in the machine and fly out of
the machine approx. 25 m in any direction. They can also bounce off solid objects and
injure bystanders or cause damage to property.
Remove loose objects from the work area!
Remove bystanders from the danger area!
Work with great care!
Bekijk gratis de handleiding van Zipper ZI-BSF1500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zipper |
| Model | ZI-BSF1500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9827 MB |
