Handleiding
Je bekijkt pagina 8 van 28
Installation
8 | Wolf Customer Care 800.222.7820
Anti-Tip Bracket
To prevent the range from tipping forward, the anti-tip
bracket must be installed. Ensure the anti-tip bolt
engages the bracket.
Install Bracket
Drywall application: After properly positioning the anti-
tip bracket, mark the holes, then use a Phillips screwdriver
or a low rpm power drill to drive the wall anchor into the
surface of the wallboard until flush. Pre-drill the holes if
needed. For hard wallboard or double-board
construction, use a
1
/
4
" drill bit. For solid plaster, use a
7
/
16
" drill bit. Use the provided #8 screws and flat washers
to fasten the bracket to the wall.
Wood floor application:After properly positioning the
anti-tip bracket, drill
3
/
16
" (5) pilot holes through the floor.
Use the provided #12 screws and flat washers to secure
the bracket to the floor.
Concrete floor application: After properly positioning the
anti-tip bracket, drill
3
/
8
" (10) holes into the concrete a
minimum of 1
1
/
2
" (38) deep. Use the provided
3
/
8
" wedge
anchors to secure the bracket to the floor.
Anti-Tip Bolt Adjustment
Once the bracket is secure, adjust the anti-tip bolt so the
top of the washer is 1
1
/
2
" (38) to 1
7
/
8
" (48) from the floor.
Slide the range into the opening and verify the anti-tip
bolt is engaged.
Bekijk gratis de handleiding van Wolf IR48751, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wolf |
| Model | IR48751 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2599 MB |
