Wiesenfield WIE-BM-100 handleiding
Handleiding
Je bekijkt pagina 29 van 228
EN
• Maintaining electrical cables: Always keep the cables dry and clean. Disconnect the power supply when
the machine is not in use.
• Pollution prevention: Check the tank regularly to prevent the ingress of stones, iron filings and other
foreign objects. If abnormalities are detected, stop work immediately.
Ending work:
• Before switching off the machine, make sure that the tank is empty. Then, engage reverse gear for one
minute to remove material debris from the worm shaft.
Security:
• Grounding the machine: Do not start the machine unless it is properly grounded. This is essential for
operator safety and equipment protection.
3.5. Cleaning and maintenance
General recommendations for cleaning and maintenance
a) Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use. Wait until the rotating parts stop.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all parts should be thoroughly dried before the device is reused.
d) Store the unit in a dry and cool place protected from moisture and direct sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the unit checking technical fitness and any damages.
i) Use a soft, damp cloth for cleaning.
Disposal of used devices
At the end of its useful life, this product should not be disposed of with normal household waste but should be
taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by the symbol
on the product, operating instructions, or packaging. The materials used in this appliance are recyclable according
to their marking. By reusing, recycling, or applying other forms of use of waste machines, you make a significant
contribution to the protection of our environment.
Your local administration will provide you with information about the appropriate disposal point for used
appliances.
Worm shaft repair
The worm shaft should be repaired or replaced after 24 hours of normal use (approximately 6-7 tons of
processed material) or if there is evidence of wear or damage.
Signs of a worn/damaged worm shaft:
• Significant reduction in briquette production speed.
• Consistent jamming despite the raw material being within the required moisture and temperature
range.
• Briquette production is possible, but the sections do not connect.
• Fast production of briquettes with a loose structure and low density.
• The wear on the front end of the worm shaft is greater than 4 mm.
• The diameter of the inner hole of the finished briquette is less than 15 mm.
• Wear of the helical part of the worm shaft due to foreign objects or other causes.
Bekijk gratis de handleiding van Wiesenfield WIE-BM-100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-BM-100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 106066 MB |
