Whirlpool WDT550SAPZ handleiding
Handleiding
Je bekijkt pagina 27 van 64
27
1. Connect rubber end (A) of drain hose to air gap and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Attach drain hose to air gap with drain hose clamp (black
color) (provided). Use pliers to squeeze clamp open and move
into position. If the drain hose was cut, use a 1
1
/
2
" to
2" (38 mm to 50 mm) screw-type clamp (not provided).
3. Use a rubber hose (not provided) with screw-type clamps (not
provided) to connect from waste tee to air gap.
Complete Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
33. Power supply cord – Plug into a grounded 3
prong outlet
A
D
B
C
A. Junction box cable
B. Junction box
C. Cable fittings (2)
D. Power cord
Plug into a grounded 3-prong outlet.
34. Reconnect power
Reconnect electrical power at the fuse box or circuit breaker
box.
NOTE: With the access panel off, start the dishwasher and
allow it to complete the shortest wash cycle. After the first
2 minutes, unlatch door, wait 5 seconds, and then open door.
Check that there is water in the bottom of the dishwasher tub.
Check that dishwasher is working properly.
Install Access Panel
35. Install the toe panel
Install the toe panel as shown in the above image.
36. Check toe panel edge
Check that the lower edge of the toe panel touches the floor.
Adjust if necessary.
Bekijk gratis de handleiding van Whirlpool WDT550SAPZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WDT550SAPZ |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 11080 MB |
