Whirlpool WDT550SAPZ handleiding
Handleiding
Je bekijkt pagina 19 van 64
19
WARNING
Electrical Shock Hazard
Electrically ground appliance.
Connect wires together inside the junction box using the
supplied wire nuts.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Direct Wire Connection
1. Route the junction box cable from the dishwasher through the
electrical conduit hole in the cabinet wall. Also route the home
wiring through the same hole as shown below.
A
D
B
C
A. Junction box cable
B. Junction box
C. Cable fittings (2)
D. Home wiring
2. Refer to “Junction Box Assembly” section of this Owner’s
Manual to attach cable fitting to the home wiring and its
assembly.
3. After the complete assembly of Junction box with home wiring,
Secure the junction box to the back of the cabinet wall using
four screws (not provided). Be sure to avoid driving screws
into utility lines possibly located in the wall behind the junction
box.
Power Cord Connection
1. Use power cord kit (sold separately per Whirlpool Part
Number W11670634) and Junction box assembly (included)
for connecting the dishwasher to the power supply as shown
below. The power cord kit includes a straight plug that is
recommended for most installations.
NOTE: To ease some installations, a power cord with a right
angle plug is also available per Whirlpool Part Number
W11546624.
A
D
B
C
A. Junction box cable
B. Junction box
C. Cable fittings (2)
D. Power cord
IMPORTANT: Do not plug cord into an outlet until instructed to
do so.
2. Refer to “Junction Box Assembly” section of this Owner’s
Manual to attach cable fitting to the power cord and its
assembly.
3. After complete assembly of Junction box with Power cord,
Secure the junction box to the back of the cabinet wall using
four screws (not provided). Be sure to avoid driving screws
into utility lines possibly located in the wall behind the junction
box.
Junction Box Assembly
1. The junction box comes in a plastic bag located inside a
cardboard box in the lower rack of the dishwasher (previously
removed at the beginning of the installation process).
DANGER
Electrical Shock Hazard
Disconnect power before servicing.
Fully assemble cable fittings.
Place all wiring inside junction box.
Replace cover before reconnecting power.
Failure to do so can result in death, fire, or electrical
shock.
2. Route the junction box cable from the dishwasher through the
electrical conduit hole in the cabinet wall.
3. Use a #2 Phillips screwdriver to remove the Junction box lid
from the junction box (4 screws).
Bekijk gratis de handleiding van Whirlpool WDT550SAPZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WDT550SAPZ |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 11080 MB |
