Warmup VLo Econna-12 handleiding
Handleiding
Je bekijkt pagina 10 van 28
10
10 mm
10 mm
• If the oor void is accessible
from below, steps 4 - 9 can be
completed for the whole oor
deck, no access panels will be
required.
• If the oor void is not accessible,
installation of the Econna-12
panels must be completed room-
by-room, beginning from the
room furthest from the manifold.
• Lay the rst panel in the corner
of the room, perpendicular to the
joists, leaving a minimum 10 mm
gap between the end and edge of
the panel and the walls. The two
groove edges of the panel should
be placed in the corner. The
opposite end of the panel must sit
on the centre line of a joist.
• The joist space must be
pre-insulated in line with building
regulations
• Ensure the joists are level and
even, clear of debris and without
any surface deviations such as
knots or nails before laying the
Econna-12 panels.
• Drill a 12.5 mm hole in this rst
panel at a 20° angle where the
ow pipe needs to drop into the
joist space.
• Feed the pipe through the hole
through to the manifold location,
notching/drilling the joists as
required in line with building
regulations.
• It is recommended that the
shortest length of panel should
be supported across a minimum
of three joists, e.g. if the supports
are set nominally at 400 mm
centres, the shortest panel length
should be 800 mm. If a shorter
panel is required it must be
supported by noggins.
21
3 4
Step 2 - Install VLo Econna-12
65
Bekijk gratis de handleiding van Warmup VLo Econna-12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | VLo Econna-12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6226 MB |
