Warmup Foil Heater handleiding
Handleiding
Je bekijkt pagina 6 van 42
6
Safety information
Perform a site inspection. You will need to conrm that all
measurements and other requirements on site match your
working drawings.
Inspect the site for possible hazards that could damage the heating
mat, such as nails, staples, materials or tools. Ensure that during
the course of the installation no damage is caused to the heating
mat by falling or sharp objects.
Ensure all electrical connections conform to the current
BS 7671 National Wiring Regulations. Final connections to the
main electricity supply MUST be completed by a Part P qualied
electrician�
Ensure the system is protected by a dedicated 30 mA RCD/RCBO or
an existing RCD/RCBO). Time delay RCD‘s must not be used.
Ensure that the control card at the back of the manual is
completed and xed at the consumer unit along with any plans
and electrical test records as per the current edition of BS 7671.
The suboor must be pre-insulated unless it is an intermediate
oor. Ensure the suboor is prepared to an SR1 Surface Regularity.
The suboor must be smooth, dry, frost-free, solid, suitably weight-
bearing and dimensionally stable.
Ensure timber suboors are prepared in accordance with national
standards and manufacturer instructions are properly followed to
avoid suboor movement to prevent any damage to the system.
Install the oor sensor centrally between two parallel runs of
heating cable and away from other heat sources such as hot water
pipes, lighting xtures, chimneys etc. Do not cross the sensor over
the heating element�
Before installing the oor nish, its suitability for use with
underoor heating and its maximum operating temperature
should be checked against required operating conditions. Ensure
the heat output of the oor meets your requirements.
Install oor coverings which are at least 5 mm thick. For oor
coverings other than oating wood/laminate oors, lay Warmup
WDO / HiDeck18 over the heater rst. Check with ooring
manufacturer for suitability with oor heating.
Ensure glues/adhesives used over Warmup Dual Overlay/Hideck18
are compatible with underoor heating and suitable for application
with electric underoor heating systems.
Consideration should be given to the thermal resistance and
temperature limits of the chosen oor covering and its impact on
the system heat output�
Ensure all furniture installed over underoor heating has feet,
creating a minimum 50 mm ventilated space beneath it to allow
heat ow into the room.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
Bekijk gratis de handleiding van Warmup Foil Heater, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Foil Heater |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11009 MB |
