Warmup Foil Heater handleiding
Handleiding
Je bekijkt pagina 7 van 42
7
Safety information
Insulation MUST be used below the Warmup Foil Heater and MUST
be minimum 6 mm thick and ≤ 500kPa compressive strength.
DO NOT cut, shorten or extend the heating cable. The heating mat
must not overlap or be installed over coldtails.
DO NOT leave surplus heating mat rolled up under units or
xtures, use the correct size system for your installation.
DO NOT attempt a DIY repair if you damage the heating cable,
contact Warmup for assistance�
DO NOT tape over the oor sensor tip. Doing so will cause air
pockets and damage the sensor.
DO NOT install items above the heating system which have a
combined resistance of more than 0.175 m²K/W. Such items
include bean bags, heavy rugs, at furniture, animal beds or
mattresses�
DO NOT bend the heating cable under 25 mm radius.
DO NOT install the heating mat in ambient temperatures less
than 0 °C�
DO NOT install any levelling compounds/tile adhesives over the
heating mat or have the mat in direct contact with a cement
or concrete suboor or slab. There must always be a suitable
underlay underneath the heater.
DO NOT install the system on irregular surfaces such as on stairs
or up walls.
DO NOT use staples to secure the heating mat to the suboor.
DO NOT install the heating mat in locations where they will
increase the ambient temperature of any existing electrical
installation above its rated value.
Failure to comply with local wiring regulations or the
contents of this manual may result in electric shock
or re!
WARNING! Radiant direct oor heating system.
Risk of shock or re
Bekijk gratis de handleiding van Warmup Foil Heater, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Foil Heater |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11009 MB |
