Vulcan C24EO3AF handleiding
Handleiding
Je bekijkt pagina 15 van 43
SPRING MOUNTED HEATER ASSEMBLY (First
Production)
The heater contains elements that are molded into a
cast aluminum block. The springs compress to hold
block tight to bottom surface of compartment but allow
for thermal expansion and contraction.
Heater Removal
1. Remove right side panel on steamer.
2. Remove screw and heat shield.
Fig. 26
3. Remove bolts.
NOTE: Support heater element block while removing
last bolt. Heat shield assembly (tray) is hinged on
opposite side and will tilt down after the last bolt is
removed.
Fig. 27
4. Disconnect heating element leads from 1CON
and 2CON, noting their locations.
Fig. 28
5. Partially remove heater block from heat shield
assembly (tray) by pulling assembly towards you.
6. Remove high limit thermostat bulb and bracket.
Fig. 29
7. Remove heater element block from steamer.
Heater Installation
NOTE: When performing heater Installation for 3 pan
unit with 240V supply, disconnect and insulate
element leads with orange, green, and red markers
(three 664W elements not used).
NOTE: Scrape off as much of the old thermal transfer
compound from underside of cooking compartment as
possible before installing replacement heater
element.
1. Completely and evenly coat contact face of the
replacement heater element block with heat sink
compound using notched trowel. Use
approximately one 13.5 oz. tube of thermal
transfer compound to cover the surface.
C24EO SERIES ELECTRIC COUNTERTOP STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
Page 15 of 43 F25386 Rev. C (0421)
Bekijk gratis de handleiding van Vulcan C24EO3AF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | C24EO3AF |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15986 MB |
