Vulcan C24DA10 handleiding
Handleiding
Je bekijkt pagina 18 van 65
Fig. 30
4. Disconnect wires to burner assembly.
5. Disconnect wires from gas combination control
valve.
6. Remove the nuts securing the burner to
generator.
7. Drop blower end of burner assembly slightly
down to clear control box and push all wires out
of the way so that burner can be pulled out of
tank.
8. Disconnect wires from the operating pressure
switch.
9. Loosen hose clamp attaching lower flexible water
line at back panel and use a wrench to disconnect
barb fitting from main inlet water connection.
10. Loosen hose clamp attaching upper flexible
water line at back panel and use a wrench to
disconnect barb fitting from main inlet water
connection.
11. Remove water line from generator. Remove
steam hoses from steam trap and supply to super
heater.
12. Disconnect gas tubing from rear panel.
13. Remove steel drain tube at tank.
14. Disconnect union between tank and drain.
15. Loosen cable clamp screws securing electrical
cable at rear panel so that cable is free to move.
16. Remove screws to free super heater and lift
super heater off flue pipe, if applicable.
Fig. 31
17. Rotate pressure relief valve coupling to allow
pressure relief valve to be rotated about 90° so
that valve is below generator top level.
18. Remove pressure switch from generator.
Fig. 32
19. Remove bolts attaching front of generator to
frame.
C24GA AND C24DA SERIES CONVECTION STEAMER - REMOVAL AND REPLACEMENT OF PARTS
F35425 Rev. E (0119) Page 18 of 65
Bekijk gratis de handleiding van Vulcan C24DA10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | C24DA10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16865 MB |
