Vulcan C24DA10 handleiding

65 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 12 van 65
COOKING COMPARTMENT DOOR
Removal
1. Close Door.
2. Remove compartment left SIDE PANEL.
3. Remove nuts from top door support bracket.
Fig. 9
4. Open door slightly, and while holding door, pull
upper hinge away from front panel.
5. Pull upper hinge out of upper door hinge bushing.
6. Lift door assembly up and off lower door hinge.
7. Reverse the procedure to install and check for
proper operation.
8. Reinstall parts removed in reverse order of
removal.
9. Check door for fit and proper sealing of gasket.
Gasket
1. Open the door.
2. Remove the shoulder screws and pan pusher
bracket from gasket plate.
Fig. 10
3. Remove the gasket plate.
4. Remove gasket from inner door panel.
5. Remove RTV from bottom part of inner door
panel. Apply new RTV 109 to bottom of door
where shown when assembling gasket to door.
6. Place a small amount of RTV109 into the inner
door panel gasket screw holes before assembly.
7. Position the new gasket on gasket plate and
reverse procedure to install
NOTE: Damage to the gasket sealing surface, such
as nicks or cuts, will cause steam leakage.
Handle Removal
1. Open the door.
2. Remove screws from the top and bottom of the
door.
Fig. 11
3. Pull outer door housing away from inner door
panel starting at the hinge side of door to
separate the door halves.
4. Remove lock nuts and stepped spacers from
threaded studs of door handle.
Fig. 12
C24GA AND C24DA SERIES CONVECTION STEAMER - REMOVAL AND REPLACEMENT OF PARTS
F35425 Rev. E (0119) Page 12 of 65

Bekijk gratis de handleiding van Vulcan C24DA10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkVulcan
ModelC24DA10
CategorieNiet gecategoriseerd
TaalNederlands
Grootte16865 MB