Voltcraft DOV702 handleiding
Handleiding
Je bekijkt pagina 17 van 37
Error! Use the Home tab to apply 标题 1 to the text that you want to appear
here..Error! Use the Home tab to apply 标题 1 to the text that you want to appear
here.
15
measuring error or mistake. For adjusting the probe compensation, please
carry out the following steps:
1、 Set the attenuation coefficient of the probe in the menu as 10X and that of
the switch in the probe as 10X (see "How To Implement The
Probe Compensation" on P14), and connect the probe with the
CH1 channel. If a probe hook tip is used, ensure that it keeps in close
touch with the probe. Connect the probe tip with the signal connector of
the probe compensator and connect the reference wire clamp with the
ground wire connector of the probe connector, and then push the Autoset
button on the front panel.
2、 Check the displayed waveforms, see Figure 3-5. Regulate the probe till a
correct compensation is achieved, see Figure 3-6: Adjust Probe.
Overcompensated Compensated correctly Under compensated
Figure 3-5: Displayed Waveforms of the Probe Compensation
Figure 3-6: Adjust Probe
3、 Repeat the steps mentioned if needed.
Bekijk gratis de handleiding van Voltcraft DOV702, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Voltcraft |
| Model | DOV702 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7226 MB |
