Vivolink VLVWIP2000-DEC handleiding
Handleiding
Je bekijkt pagina 20 van 34
7, eARC/ARC or S/PDIF audio return settings: After entering the configuration mode,
press the UP/DOWN button to enter the fourth page with “ARC/SPD” displaying on the
LED screen (ARC by default). Press and hold UP + DOWN buttons for 5 seconds, then
release to enter the audio return settings mode, in which the audio return mode (ARC/
SPD) on the LED screen will flash at 1Hz, then press the UP/DOWN button to select
the mode, then press and hold UP + DOWN buttons for 5 seconds to confirm the
setting and stop flashing. The corresponding audio return mode options are as follows:
ARC: eARC/ARC audio return (The audio from the HDMI OUT port of Decoder is
transmitted back to the HDMI IN port of the Encoder.)
SPD: S/PDIF audio return (The audio from the S/PDIF IN port of Decoder is transmitted
back to the S/PDIF OUT port of the Encoder.)
Note:
(1) The audio return mode can not be modified through front panel buttons in
Controller Box or Multicast mode.
(2) Only when both the Encoder and Decoder are set to C2C audio return mode, the
eARC/ARC or S/PDIF audio return can be realized.
(3) When to use ARC, ARC audio amplifier on Encoder HDMI IN port and ARC TV on
Decoder HDMI OUT port should be used.
When to use eARC, eARC audio amplifier on Encoder HDMI IN port and eARC TV
on Decoder HDMI OUT port should be used.
8, IP mode settings: After entering the configuration mode, press the UP/DOWN button
to enter the fifth page with “IP1/IP2/IP3” displaying on the LED screen (IP3 by default).
Press and hold UP + DOWN buttons for 5 seconds, then release to enter the settings
mode, in which the IP mode (IP1/IP2/IP3) on the LED screen will flash at 1Hz, then
press the UP/DOWN button to select the mode, then press and hold UP + DOWN
buttons for 5 seconds to confirm the setting and stop flashing. After setting, the unit
will reboot automatically.
The corresponding IP mode options are as follows:
IP1: Static IP mode (Default IP address: 169.254.100.253)
IP2: DHCP IP mode
IP3: Auto IP mode (Default assigned network segment: 169.254.xxx.xxx)
Note: The IP mode can not be modified in Controller Box mode.
9, Fiber/Copper mode settings: After entering the configuration mode, press the UP/
DOWN button to enter the sixth page with “CPP/FIB” displaying on the LED screen
(CPP by default). Press and hold UP + DOWN buttons for 5 seconds, then release to
enter the settings mode, in which the Copper/Fiber mode (CPP/FIB) on the LED screen
will flash at 1Hz, then press the UP/DOWN button to select the mode, then press and
hold UP + DOWN buttons for 5 seconds to confirm the setting and stop flashing. After
setting, the unit will reboot automatically.
The corresponding Fiber/Copper mode options are as follows:
CPP: Copper mode
FIB: Fiber mode
14 / 27
JPEG2000 AVoIP Encoder and Decoder
Bekijk gratis de handleiding van Vivolink VLVWIP2000-DEC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-DEC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1508 MB |
