Vimar RS05 handleiding
Handleiding
Je bekijkt pagina 23 van 32
21
VIMAR group
4.7 Connecting the aerial
The 17 cm rod is supplied pre-wired, to increase the range connect the aerial art. ZL43 as shown in the figure:
5 Description of the LEDs in the circuit:
Abbreviation Description
AC Shows whether there is mains power (lit if there is mains voltage)
STPA Displays the status of the STPA input (terminal 16), if not engaged the green LED remains lit, if not used then jumper
between terminal COM and STPA
AP/CH Displays the status of the AP/CH input (terminal 11), if not engaged the red LED remains off
APED Displays the status of the APED input (terminal 12), if not engaged the red LED remains off
STOP Displays the status of the STOP input (terminal 14), if not engaged the green LED remains lit, if not used then jumper
between terminal COM and STOP
FOTO Displays the status of the FOTO input (terminal 15), if not engaged the green LED remains lit, if not used then jumper
between terminal COM and FOTO.
FCAP
Displays the status of the opening limit switch with dip2-2 off, the green LED goes out when the gate is fully open.
Displays the status of the closing limit switch with dip2-2 on, the green LED goes out when the gate is fully closed.
FCCH
Displays the status of the closing limit switch with dip2-2 off, the green LED goes out when the gate is fully closed.
Displays the status of the opening limit switch with dip2-2 on, the green LED goes out when the gate is fully open.
ENC.A
Displays the encoder A input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with
the motor stopped.
ENC.B Displays the encoder B input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with
the motor stopped.
DL12 Displays the programming status of the travel and of the radio control learning (two-colour LED)
Buttons in the circuit:
Abbreviation Description
AP/CH Controls opening and closing the gate
P3 Press to enter travel programming
P2 Press to enter radio controls programming or deletion
Preliminary check:
After powering up the control unit the DL12 LED comes on for a second.
Check the
LEDS for diagnosis of the inputs, STOP, FOTO and STPA must be on.
Should one of the safety inputs (FOTO, STOP, STPA) not be used, insert a jumper between COM and the input not used.
Fig. 12
EN
Bekijk gratis de handleiding van Vimar RS05, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vimar |
| Model | RS05 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2892 MB |
