Vimar 01532 handleiding

Niet gecategoriseerd

Vimar

74 pagina's

PDF beschikbaar

Handleiding

BUILDING AUTOMATION

Parameter “Delay for switch off: (0...240 min) / (0...59 s)”

This parameter defines the delay time of switching off. Options:

0…240 Minutes

0…59 Seconds

After receiving the delay off telegram, the switch is off once the delay over.

If receiving the re-trigger telegram again during delay, the delay will be reset.

4.3.2.2 Selection “Flashing”

The parameter window “Ox: Time-Flashing” setting interface in Fig. 4.6 will be shown up when selecting “flashing” in the parameter “Type of time func-

tion”. The flashing switch function is mainly used for lamp aging test.

Fig. 4.6 Parameter window “Ox: Time-Flashing”

Flashing function can be started via the object “Flashing function”. It is able to set the flashing time in “Delay for switch on” or “Delay for switch off”, which

will restart the flashing when receiving the start flashing telegram, and define the contact position after flashing

Parameter “Delay for switch on: (0...240min) , (0...59s)”

This parameter defines the duration of the switch on the output when flashing. Options:

0…240 Minutes

0…59 Seconds

Note: It will not be executed unless the time is lower than the relay threshold switch frequency. Since there will be not sufficient energy to do

it because of the frequent relay switching, and it may cause the time delay. The same situation will happen after the bus voltage recovery.

Parameter “Delay for switch off: (0...240min) , (0...59s)”

This parameter defines the duration that the switch is turned off the output when flashing. Options:

0…240 Minutes

0…59 Seconds

Note: It will not be executed unless the time is lower than the relay threshold switch frequency. Since there will be not sufficient energy to do

it because of the frequent relay switching, and it may cause the time delay. The same situation will happen after the bus voltage recovery.

Parameter “Number of ON-impulsed (1...255, 0=no limited)”

This parameter sets the flashing times. 0 means no limited. A flashing includes an on and an off. Options:

0...255

Parameter setting description in the ETS

Bekijk gratis de handleiding van Vimar 01532, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.