Vevor ZX0901 ITEM 50T handleiding
Handleiding
Je bekijkt pagina 8 van 80
1. 50-Ton Shop Press comes with two Arbor Plates. The Arbor Plates can be used
individually or connected as shown below by the Arbor Lock.
2. The gap between the two plates is expandable from 0-5” . To adjust the space
between the two Arbor Pates, loosen each bolt on the side of the plates, adjust the
gap between the plates, then retighten the bolts before use.
3. To set the Aprons at a specific height, slide the two Pins through opposite
adjustment holes on the Press Frame legs and secure in place using the two
R-Clips.
4. Place the Arbor Plate onto the Press Apron , making sure to center it on the
Press Apron.
5. WARNING! If the Arbor Plates rest on an obstruction (such as bolt, debris, etc.)
an uneven base can be created. This can lead to unusual stress on the Arbor
Plates and possibly a break and/or personal injury.
6. Insert the narrower jack handle (the end with the pin) into the larger handle and
engage the pin into the “T” slot.
7. Using the slotted end of the jack handle, tighten (turn clockwise) the relief valve
of the Jack.
8. Insert the larger tube of jack handle into the Jack Handle Connector located to
the side of the Jack .
9. pump the handle up and down to extend the Jack and operate the Shop Press.
10. WARNING! Should you detect any kind of structural failure, stop using the
Shop Press immediately. If necessary, have the unit repaired by a qualified service
technician.
11. When finished, remove the jack handle from the Jack Handle Connector and
loosen (turn counter-clockwise) the relief valve of the Jack .
Bleeding
1. Remove the Oil Fill Plug located on the back of the Jack to expose the Oil Fill
Hole.
2. Open the Release Valve located on the front of the Jack,above. Insert the Jack
Handle into the Pump Core. Slowly pump handle to force air out of the Oil Fill Hole.
3. As soon as the oil starts to come out of the hole, stop pumping. Replace the Oil
Fill Plug. Close the Release Valve.
4. Check the oil level. It must be just below the Oil File Hole. If necessary, fill with
high quality hydraulic oil 15#.
Bekijk gratis de handleiding van Vevor ZX0901 ITEM 50T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | ZX0901 ITEM 50T |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9741 MB |
