Vevor ZX0901 ITEM 50T handleiding
Handleiding
Je bekijkt pagina 7 van 80
OPERATION INSTRUCTION
The wire rope is wound as shown on the above, pay attention to make sure that
the wire rope has been wound on the upper and lower four pulleys before use.
The table rises:
The pawl pivots upward, and the handle can be cranked clockwise to bring the
worktable up and thread the pin into the appropriate hole. Then pawl pivots
downward again, cranking the handle counterclockwise to place the table onto the
pin so that the wire rope is no longer under tension.
table onto the pin so that the wire rope is no longer under tension.
The table is lowered:
Pawl upward dial, clockwise crank the handle, the worktable up a little and pull the
pin out. Then, pawl downward pawl, crank the handle counterclockwise, put the
table to the the appropriate position, put the pin into the corresponding hole,
counterclockwise Crank the handle counterclockwise to place the table on the pin
so that the steel the wire rope is no longer under tension.
Bekijk gratis de handleiding van Vevor ZX0901 ITEM 50T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | ZX0901 ITEM 50T |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9741 MB |
