Vevor RB-25 handleiding

224 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 23 van 224
- 22 -
making a cut.
·Screw in stopper to provide sufficient clearance for rebar.
·Insert rebar fully into U-shaped support. Make sure that rebar is resting on
the base of the stopper.
·Keeping rebar at right angels (90°) to front cutter block, screw out stopper
until it is just touching the rebar. Once set, the stooper needs no further
adjustment while cutting rebar of the same diameter, but must be re-set for
a different size rebar.
Caution: Failure to correctly set the stopper will result in excessive wear of
cutter block and may cause cut end to fly out.
Cutting
1.Insert rebar between stopper and front cutter block, making sure that it is
properly seated in U-shaped support.
2.Pull trigger -switch and keep depressed while piston advances and rebar
is cut. ( If switch is released at an intermediate point, piston will stop.)
3.When cut is completed, release switch. Piston retracts automatically.
(Note that switch can't be re-activated until piston has fully retracted.)
Points of attention
1.Be especially careful when cutting off short lengths (30cm or less) as the
cut end tends to fly out.
!Caution : Flying ends are a hazard to all personnel in the vicinity. Erect
safety screens.
2.Do not cover air vents.
Care: If events are covered , motor will overheat and may burn out.
3.If hydraulic oil exceeds 70 ° (158 F) in temperature, power will drop.
Allow until to cool before resuming operation. (Be particularly careful in
summer, when the aluminum pump case heats up quicker.)
4.If a drop in power is observed and motor is unusually hot, check carbon
brush .
5.If piston should ever fail to retract completely, push rear cutter block
backwards to manually retract piton.

Bekijk gratis de handleiding van Vevor RB-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkVevor
ModelRB-25
CategorieNiet gecategoriseerd
TaalNederlands
Grootte22625 MB