Vevor RB-25 handleiding
Handleiding
Je bekijkt pagina 24 van 224
- 23 -
Caution: Use a rebar or flat metal bar for this purpose. Never push cutter
block with any part of the hand, even if gloved.
Once piston has been retracted , pull trigger-switch long enough to partially
advance piston. Unplug unit. And check piston and housing for
accumulated dust iron filings that may be jamming the piston. After
cleaning, piston still does not automatically retract when fully extended, the
piston itself may be damaged. Return the unit to an authorized agent for
repair.
Maintenance
Cutter blocks
Before using, always check that the two bolts on each cutter block are
properly tightened. Using a loose block will result in damage to block and
housing. Also check condition of cutter blocks. If either cutting edge is dull
or chipped, remove retaining bolts and rotate both blocks so that two new
edges come into use. Replace and tighten bolts (each block has four
cutting edges)
When all four cutting edges have been used or if either block is cracked or
otherwise damaged, replace both block.
Caution: A loose or cracked block may result in injury to operator.
Cleaning
Cleaning cutter after use.
Caution: Wear gloves to protect hands from metal splinters. Do not use an
air-gun, blasting with air can cause metal filing and/or dust to get into eyes
and respiratory system.
1.Disconnect unit.
2.Wipe or brush away all dirt and metal filings. Pay particular attention to
the lower half of the piston, where dirt is more easily accumulated.
Bekijk gratis de handleiding van Vevor RB-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | RB-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22625 MB |
