Vevor GQ-100D handleiding
Handleiding
Je bekijkt pagina 21 van 275
- 20 -
steps until you feel the blockage.
Pay attention to:
Control the spring hand as close to the pipe inlet as possible to prevent the spring
from twisting.
1. When encountered, move the spring back and forth to remove the obstruction.
In this regard, the speed of the spring advance depends on the extent of the pipe
blockage and the nature of the blockage, please slow forward.
2. If the spring encounters the obstruction and struggles, please release the clutch
handle immediately to stop the spring rotation, and then slowly push the spring into
the block again. Repeat the above steps until the block is cleared.
3.If the spring is stuck in the block, immediately release the clutch handle, and
place the machine switch in the OFF gear. When the machine is completely
stopped, place the switch in CCW gear, push down the clutch handle. When the
tool or cable leaves the block, please release the clutch handle immediately, then
place the machine witch in OFF gear, and then put the machine switch in CW gear
for normal operation.
4. When the blockage is dredged, the user is advised to flush the pipe with clean
water and repeat step 7 several times to completely dredge the pipe.
Pay attention to:
The spring is not fixed in the chamber. When the spring is pulled out of the
chamber, hold the spring to prevent the spring from falling into the pipe and push
the spring back into the chamber by hand.
1. If the spring is drawn from the pipe, place the machine switch knob in the CW
gear, press the clutch handle, and gently remove the cable.
2. Release the clutch handle, push the pulled spring into the fuselage by hand and
back to the spring bin.
3.Release the clutch handle before the spring fully exits the pipe.
4.Place the machine switch knob in the OFF gear.
5.Pull the remaining springs out of the pipe and push them into the fuselage.
Special explanation:
Reverse operation:
The machine switch is reversed in CCW gear, which may cause damage to the
spring. This operation is only used to exit the tools and springs from the block.
Bekijk gratis de handleiding van Vevor GQ-100D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | GQ-100D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 49458 MB |
