Vestil STAND-G-V handleiding
Handleiding
Je bekijkt pagina 6 van 9
Table of Contents 8/11/2023 STAND-G, MANUAL
Table of Contents Vestil Manufacturing Co. 2023 Page 6 of 9
6. Insert the inner cylinder sleeve into the top opening of the cylinder cover. Tighten the set
screw in the collar at the top of the sleeve. Tightening the set screw constricts the opening
at the top end of the cylinder cover against the inner sleeve.
7. Place the roller subassembly onto the top of the inner sleeve. Tighten the set screw against
the side of the inner sleeve to secure the roller head in position. NOTE: Subassembly STAND-
V15-RBA for models STAND-G-V and STAND-G-V-HP shown.
USING THE STAND
Place the stand appropriately to support the item/material being worked on.
Loosen the set screw at the top end of the cylinder cover. See ASSEMLING THE STAND-G,
Step 6, on p. 6.
Press the pedal lever with your foot to extend the cylinder and raise the roller
subassembly. See ASSEMBLING THE STAND-G, Step 3, on p. 5. When the roller subassembly
reaches the desired height, release the pedal.
To lower the roller subassembly, press and hold the pedal lever with your foot.
Simultaneously, press down on the roller head. Release the pedal when you finish adjusting
the height of the roller head.
Set
screw
Bekijk gratis de handleiding van Vestil STAND-G-V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | STAND-G-V |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4926 MB |
