Vestil PJ-LIFT handleiding
Handleiding
Je bekijkt pagina 6 van 8
TABLE OF CONTENTS Rev. 5/7/2021 PJ-LIFT, MANUAL
TABLE OF CONTENTS Copyright 2017 Vestil Manufacturing Corp. Page 6 of 8
LOADING THE HOIST
1. Drive the pallet truck, with the hoist installed, into the fork channels of the skid supporting the load.
2. Apply appropriate rigging to the load.
3. Turn the winch handle counterclockwise to lower the load hook. Lower the hook so that the load rigging
can be attached to it. The center of the load should be directly below the hook to prevent load swing as it
rises off of the skid. The following diagrams illustrate proper and improper positioning.
Improperly positioned loads
5. Turn the winch handle clockwise to raise the load. Only raise the load a few inches above the skid.
6. Back the truck out of the skid and lower the load onto the fork pockets (of the hoist). If the load is too
narrow to rest on both pockets, place a pallet (or plywood) on the pockets.
7. Carefully move the truck to the unloading location. Raise the load. Remove the plywood/pellet. Drive
the pallet truck into the skid, and lower the load onto the skid. Disconnect the hook from the rigging.
INSPECTIONS & MAINTENANCE
Compare inspection results to the RECORD OF SATISFACTORY CONDITION. Do not continue to use
the product unless every component is in SATISFACTORY CONDITION. Cosmetic changes, like damaged
paint/powder coat do not constitute changes from satisfactory condition. However, touchup paint should be
applied to all affected areas as soon as damage occurs. Contact
TECHNICAL SERVICE to order
replacement parts. Contact information is provided on the cover page of this manual.
Inspect and maintain the unit as instructed and immediately after it sustains damage. Conduct a load test
of 125% of the rated capacity (1.25 x 500 pounds = 600 pounds) each time the crane is repaired. Raise
the test load for 1 minute. Return the lifter to the ground and unload it. Perform a Monthly Inspection
as
instructed on p. 7.
Side view
Front view
Hook/cable
aligned with
centerline of
load (red
dashed line)
Hook/cable
not aligned
with centerline
of load (red
dashed lines)
Side view
Front view
Bekijk gratis de handleiding van Vestil PJ-LIFT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | PJ-LIFT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1647 MB |
