Vestil EHLT-E-2448-2-41 handleiding

17 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 9 van 17
TABLE OF CONTENTS Rev. 11/28/2022 EHLT-E MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 9 of 17
Hydraulic Schematic (01-125-008).
ITEM
PART NO.
DESCRIPTION
QTY
1
01-127-010
MANIFOLD, LHL
1
2 99-153-011
CHECK VALVE, SIZE
08, NOSE-IN/SIDE-OUT
1
3
99-153-
038-001
FLOW CONTROL, 1.0
GPM, PRES. COMP.
1
4 99-153-006
VALVE, PRESSURE
RELIEF, 210 BAR
1
5 99-153-015
VALVE SOLENOID,
STANDARD, w/o COIL
1
INSTALLATING THE TABLE
Read the installation instructions in their entirety before installing the scissor lift table.
Consult the factory in the event of questions or problems at the time of installation.
Modifications or additions to the lift table, without prior authorization by the manufacturer, may void the
warranty. See ANSI standard MH29.1-2003, Safety Requirements for Industrial Scissor Lifts
, Section 12.6.
Attaching ancillary equipment to the platform will lower its load capacity.
The installation shall comply with all applicable regulations for its location and use.
The end user is responsible for verifying that this lift table and its installation are suitable for its environment
and application.
This lift table shall be installed only by qualified and trained personnel with access to appropriate
equipment. Electrical connections shall be performed by a qualified electrician.
Before You Begin.
The Electric Hydraulic Scissors Lift Table must be anchored to a smooth, level, and adequately strong
concrete surface. If the lift table will be installed in a pit, first determine where and how the electrical
and/or hydraulic connections will be made when the lift table is in place.
Tools and Supplies.
The following tools and supplies may be needed to install your Electric Hydraulic Scissor Lift Table. These
items are not supplied with the product.
A fork truck or hoist capable of unloading the left table and setting it in place.
A smooth, level concrete surface on which to mount the lift table.
Four concrete anchors. The customer is responsible for selecting anchors appropriate for the EHLTD
model and concrete floor conditions. DO NOT operate an unsecured lift table.
Power supply and electrical disconnect matching the motor voltage and current rating. Refer to the lift
table’s data plate, labels on the control enclosure, and the electrical diagrams in this manual. The end-user
is responsible for providing the required ground fault and short circuit protection on the electrical supply.
Motor overload protection is provided by a thermostat built into the motor.

Bekijk gratis de handleiding van Vestil EHLT-E-2448-2-41, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkVestil
ModelEHLT-E-2448-2-41
CategorieNiet gecategoriseerd
TaalNederlands
Grootte3585 MB