Vestil EHLT-E-2448-2-41 handleiding
Handleiding
Je bekijkt pagina 10 van 17
TABLE OF CONTENTS Rev. 11/28/2022 EHLT-E MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 10 of 17
Installation.
1. The platform must be lowered and fully supported under its frame when moved. Support the lift
table with straps or forks that span the entire width or length of the base frame. Remove the 4x4
wood dunnage from the base. Use care to avoid damaging the electrical and hydraulic
components in the lift table.
2. Move the lift table into position.
3. Temporarily connect the power supply to the power
cable supplied with the lift table. Raise the platform
near to its full raised height. Deploy the maintenance
prop, i.e. rotate the free end of the prop into contact
with the base frame. Lower the platform until the
maintenance prop contacts the corner of the base
frame.
To raise the platform without using a power supply,
use a hoist with straps or chain rigging, or the forks on a
lift truck. Lift from the hinged end of the platform. Use
the 4x4 wood dunnage to secure the base while lifting
the platform.
4. Anchor the frame to the floor through the four
mounting holes in the frame (circled in diagram).
5. Shim and/or grout to ensure the entire length of each
base side frame is level and fully supported. The entire
base frame must be supported with no gaps in its
foundation for the lift table to function properly.
6. Have a qualified electrician make a permanent connection to the power supply.
7. Operate the lift table through several complete raise-and-lower cycles. Verify that the upper
travel limit switch (mounted on the base frame, near the left-
side hinge) prevents further upward
travel of the platform.
8. Check the hydraulic oil level. The oil reservoir should be filled to within 1” to 1-½” of the fill hole.
Note: the reservoir is an integral part of the scissor mechanism on many models. If oil is needed,
use an anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F (ISO 32 at 40°C) or a non-
synthetic automatic transmission fluid.
9. Clean the surfaces of the table, e.g. remove debris, oil. Verify that all labels
applied to the table
are in satisfactory condition. See RECORD; also see LABELING DIAGRAM on p. 17.
Maintenance
prop
Upper travel
limit switch
Base frame
Bekijk gratis de handleiding van Vestil EHLT-E-2448-2-41, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EHLT-E-2448-2-41 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3585 MB |
