Vestil EHLT-E-2448-2-41 handleiding
Handleiding
Je bekijkt pagina 11 van 17
TABLE OF CONTENTS Rev. 11/28/2022 EHLT-E MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 11 of 17
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
After assembling and installing the scissor lift table, and before using it for the first time, make a record
describing its appearance. Thoroughly photograph the lift table from multiple angles, making sure to
photograph welds and anchor points, and all of the labels. Describe where each label is located. Collect
the photographs and writings in a file. Mark the file appropriately to identify it. This file is a record of the
table in satisfactory condition. Compare the results of all inspections to this record to determine whether the
table is in satisfactory condition. Do not use the table unless it is in satisfactory condition. Purely cosmetic
changes, like damaged paint or powder coat, do not constitute changes from satisfactory condition.
However, touchup paint should be applied to all affected areas as soon as damage occurs.
OPERATING THE TABLE
Consult ANSI standard MH29.1, Section 12, and read the owner’s/user’s responsibilities regarding the
operation, care, and maintenance of this machine.
The owner of this table must ensure that all operators
understand that safe operation is the operator’s responsibility. The
owner shall also ensure that operators are knowledgeable of, and
observe, the safety rules and practices in this section.
Standard EHLT-E series lift tables are suitable for use indoors in
most non-classified industrial locations and many commercial
locations. It is intended to lift stable, evenly-distributed,
nonhazardous materials loads having a size or footprint
approximately the same size as, or smaller than, the platform.
The drawing identifies major components of your lift table.
Loading the platform.
The load rating, in pounds, is shown on the machine data plate located on the hinged end of the
platform. This indicates the net capacity of the table for a static load that is centered and evenly
distributed on the platform. For off-center loads, the lift table’s maximum capacity is 75% of the rated
capacity for end loading (either end), and 50% for side loading (either side) (see diagram). NOTE: Always
center loads on units equipped with the –ROTATE (manual carousel option) on the carousel. Rotate loads
carefully. Do not drop loads onto the platform or carousel.
WARNING
DO NOT exceed the lift table’s load ratings. Injury to personnel or permanent damage to
the lift table can result from exceeding the listed capacity. Note: Take into account the
weight of any equipment added to the platform by third parties when determining the
maximum working load to be placed on the platform.
The platform rollers are not captured. DO NOT overhang any load over the side of the
platform. A cantilevered or overhanging load at the hinged end can cause the platform
to tilt and dump the load. For applications involving side or end edge loading, consult
the factory.
This lift table is not approved for lifting personnel.
Platform
Maintenance
prop
Scissor leg
Base frame
Side loading
50% of capacity
End loading
75% of capacity
Bekijk gratis de handleiding van Vestil EHLT-E-2448-2-41, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EHLT-E-2448-2-41 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3585 MB |
