Vestil CBB-3000-37 handleiding
Handleiding
Je bekijkt pagina 5 van 19
TABLE OF CONTENTS Rev. 4/13/2023 CBB-3000-37 MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 5 of 19
ASSEMBLING THE BALER
The following items are necessary to install the device:
Fork truck or overhead lifting device
Wrenches or socket wrenches
Retaining ring pliers.
The cardboard baler ships with the compactor subassembly (ram, platen, top plate, power unit)
disconnected from the frame channel pieces at the top of the baler subassembly. To assemble the unit:
1) Turn the turnbuckle wheel in the OPEN DOOR direction to release the door latch.
2) Open the door as widely as possible.
3) Lift the upper subassembly with a fork truck, overhead
hoist, or other suitable lifting device.
4) Align the bolt holes in the TOP PLATE (22-514-062) with the
bolt holes in the channel pieces. There are 3 channel pieces
and 3 bolt holes in each channel piece.
5) Insert 1/2”-13 x 1-1/2” bolts (11209) up through the bolt
holes in the top plate and the channel pieces. Put a 1/2” flat
washer (33012) on each bolt and secure each connection
with a 1/2”-13 lock nut (37030). Tighten all lock nuts.
6) Insert bolts (13363) through the side flange bolt holes (4 on each side. Secure each bolt with a washer
(33018) and lock nut (37039).
7) Attach the left pulley weldment to the
top plate (locations circled) with four 1/4”-20
x 1” bolts (11005) and 1/4”-20 lock nuts
(37018). Attach the right pulley weldment to
the other side of the top plate in the same
manner.
8) Slide an idler sprocket (20-042-033) onto
the sprocket peg of the left pulley weldment.
Use a snap ring tool to attach a 5/8” external
retaining ring (68013) to the peg. There is a
circumferential groove near the end of the
peg. Install the retaining ring in this groove.
Attach the remaining idler sprocket to the
sprocket peg of the right pulley weldment.
BALER SUBASSEMBLY
COMPACTOR SUBASSEMBLY
Gate
Counterweight
Left Pulley Right Pulley
Weldment Weldment
Idler
sprocket
Retaining
ring
Eyebolt
Close
Open
Frame channel
pieces
Pulley weldments
attach to circled
bolt holes.
Arrows identify bolt
holes for fastening
top plate to frame
channel pieces.
Channel
piece
11209
37030
33012
Retaining
ring
Idler
sprocket
.
.
.
.
Side
flange
bolt
holes
Side
flange
bolt
holes
Bekijk gratis de handleiding van Vestil CBB-3000-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CBB-3000-37 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5154 MB |
