Vestil CBB-3000-37 handleiding
Handleiding
Je bekijkt pagina 6 van 19
TABLE OF CONTENTS Rev. 4/13/2023 CBB-3000-37 MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 6 of 19
9) Insert an eyebolt (21-145-008) through each
bolt hole in the top of the gate. Put a flat
washer (33076) and 2 hex nuts (36102) on each
eyebolt to secure it in place. Do not tighten the
nuts against the gate frame at this point so that
the eyebolts can rotate.
10) Lift the gate and chains. Slide the gate into
the gate channels with the gate handle on the
outside.
NOTE: Steps 8 - 10 are instructions for assembling the
gate counterweight system. The baler might ship with
chains (22-145-009) already connected to
counterweights (22-514-065) and eyebolts (21-145-
008).
11) Use a bicycle chain tool to remove the rivet from
one end of a counterweight chain (22-145-009).
Align the pivot holes in the chain links with the hole in
one of the counterweight brackets and reinstall the
rivet.
12) Remove the rivet from the other end of the chain.
Align the rivet holes in the chain links with the eye of
an eyebolt (21-145-008) & reinstall the rivet.
13) Repeat steps 11 & 12 with the other chain,
counterweight, and eyebolt.
NOTE: The gate counterweights are heavy. Apply ergonomic lifting practices to avoid back injury.
14) Lift the chains and set them on the idler sprockets. Direct the
counterweights into the counterweight receivers. Notice the
orientation of the counterweight brackets.
15) Install a 1/4”-20 x 3/4” bolt (11003)
through the bolt hole at the top of a gate
channel from the outside. Tighten a 1/4”-20
lock nut (37018) on the bolt. Install another
bolt and lock nut on the other gate
channel.
16) Attach the 2 yellow electrical cords
from the power unit to the connectors on
top of the control box.
17) Connect the baler to the appropriate power source as shown in the applicable electrical circuit
diagram on page 13 (208-230V AC; 1-phase) or page 14 (208-230V/460V AC; 3-phase).
Counterweight
bracket
Chain
rivet
Counterweight
Eyebolt
Gate
channel
Bolt (11003)
& lock nut
(37018)
Counter-
weight
receiver
Counter-
weight
Chain
seated on
top of idler
sprocket
Gate chain
(22-145-009)
Insert eyebolt
through bolt
hole in top of
gate; secure
with flat
washer and 2
hex nuts
Counterweight
bracket
Bekijk gratis de handleiding van Vestil CBB-3000-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CBB-3000-37 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5154 MB |
