Vestil CBB-3000-37 handleiding
Handleiding
Je bekijkt pagina 17 van 19
TABLE OF CONTENTS Rev. 4/13/2023 CBB-3000-37 MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 17 of 19
touchup paint should be applied to all affected areas as soon as damage occurs to prevent rusting
and/or corrosion from occurring. Left untreated, rust/corrosion could become a safety concern.
INSPECTIONS & MAINTENANCE
Inspections and repairs should only be performed by qualified persons. Compare the results of each
inspection to the RECORD OF SATISFACTORY CONDITION. Do not use the machine unless all parts are in
satisfactory condition. Replace parts that are not in satisfactory condition before returning the unit to
service. Never make temporary repairs of damaged or missing parts. Only use manufacturer-approved
replacement parts to restore the unit to satisfactory condition. DON’T GUESS! If you have any questions
about the condition of your baler, contact the TECHNICAL SERVICE department. The phone number is
provided on the cover page of this manual.
At least once per month (once per week for units used more than 5 times per week), evaluate the
condition of the crusher. Repair all issues before returning it to service.
1. Electrical system: Examine the electrical system for damaged wires/cables.
2. Hoses: Inspect hydraulic hoses and fittings for cuts, bulges, tears, kinks, punctures, or other damage
causing oil leaks or that could cause leaks.
3. Ram: Empty the baling chamber and cycle the ram. Listen for unusual noises and watch for cylinder
binding during the cycle. Check the cylinder to make sure that it is not bent, cracked, etc.
4. Oil: Check the oil level in the reservoir. With the ram in the home position (cylinder fully retracted), oil
should be 2” – 2
1
/
2
” below the top of the tank. If oil is needed, add ISO AW-32 hydraulic fluid or its
equal. Change the oil at least once per year. Immediately change oil if it darkens, looks milky, or
becomes gritty. Replace the oil by removing the oil fill plug. Drain oil from the reservoir. Then, flush the
reservoir with fresh hydraulic fluid before filling it. Install the drain plug and fill the reservoir with new
hydraulic fluid. Only use ISO AW-32 hydraulic oil or its equal.
5. Labels: Make sure that all labels are in place and easily readable from a reasonable distance. See
LABELING DIAGRAM on p. 18.
6. Compacting system: Disconnect the baler from electrical power. Open the door. Inspect the platens,
cylinder, and crushing chamber. Make sure that the circular compactor platen is securely pinned to
the end of the cylinder. Determine the condition of whichever platen(s) will be used. Look for broken
welds, cracks, and other damage. Clean the chamber surfaces as needed.
7. Fork tubes: Inspect the fork tubes. Tubes should be square and rigid and free of significant rust and
corrosion.
8. Finish: Repair areas where the finish has been damaged. Use steel wool or a steel bristle brush to
remove rust before applying touchup paint to the affected areas.
Bekijk gratis de handleiding van Vestil CBB-3000-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CBB-3000-37 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5154 MB |
