Handleiding
Je bekijkt pagina 15 van 29
EN - 15
Changing injectors
Hob burners
• Cut off the main gas supply and unplug the
appliance from the mains electrical supply.
• Remove the burner caps and the adapters.
• Use a 7 mm spanner to unscrew the
injectors.
• Replace the injector with the ones from
the gas conversion kit, with the correct
diameters for the type of gas that is going
to be used, according to the gas injector
table.
Adapter
Spanner
Adapter
Cup
Burner
cap
Adjusting the minimum flame position:
First of all, make sure that the appliance is
unplugged from the mains electrical supply and
that the gas feed is open. The minimum flame
position is adjusted with a flat screw located
on the valve. For valves with a flame failure
safety device, the screw is located on the side
of the valve spindle as shown in the figures. For
valves without a flame failure safety device,
the screw is located inside the valve spindle
as shown in the figure. To make adjusting
the flame position easier, we recommend
that you remove the control panel (and the
micro switch if your model has one) during the
alteration. The bypass screw must be loosened
for conversion from LPG to NG. For conversion
from NG to LPG, the bypass screw must be
tightened.
Bypass screw
Screw(inside the hole)
Valve with flame failure
device
Valve with flame failure
device
Determining the minimum flame position
To determine the minimum position, ignite the
burners and leave them on in the minimum
position. Remove the knobs because the
screws are accessible only when the knobs are
removed. With the help of a small screwdriver,
fasten or loosen the bypass screw by around
90 degrees. When the flame has a length of
at least 4mm, the gas is well distributed. Make
sure that the flame does not die out when
passing from the maximum position to the
minimum position. Create an artificial wind
with your hand towards the flame to see if the
flames are stable.
Changing the gas inlet
For some countries, the gas inlet type can
be different for NG/LPG gases. In this case,
remove the current connection components and
nuts (if any) and connect the new gas supply
accordingly. In all conditions, all components
used in gas connections should be approved
by local and/or international authorities. In all
gas connections, refer to the “Assembly of gas
supply and leakage check” clause explained
above.
2.5 Electrical Connection and
Safety (if available)
WARNING: The electrical connection of
this appliance should be carried out by an
authorised service person or qualified
electrician, according to the instructions in this
guide and in compliance with the current local
regulations.
WARNING: THE APPLIANCE MUST BE
EARTHED.
• Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
appliance’s power rating (also indicated on
the identification plate).
• During installation, please ensure that
isolated cables are used. An incorrect
Bekijk gratis de handleiding van Vestel Retro SF 84011 DG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | Retro SF 84011 DG |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 2670 MB |
