Valberg 14S40 B XAD929C V2 handleiding
Handleiding
Je bekijkt pagina 12 van 168
10
EN
• This precaution is needed to avoid the risk of the water inlet to be blocked and damage
the appliance.
ordinary supply hose
safety supply hose
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its intervention by
blocking the flow of water in case of the supply hose breaking and when the air space between
the supply hose itself and the outer corrugated hose is full of water.
WARNING!
A hose that attaches to a tap can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected
and the hole plugged.
How to connect the safety supply hose
1.
Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4 inch.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the
sink, making sure to avoid bending or crimping it. The height of drain pipe must be less than
1000mm. The free end of the hose must not be immersed in water to avoid the back flow of it.
WARNING!
Please securely fix the drain hose in either position A or position B.
Product usage
B
Bekijk gratis de handleiding van Valberg 14S40 B XAD929C V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | 14S40 B XAD929C V2 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 15217 MB |
