Tronic TLG 400 B2 handleiding
Handleiding
Je bekijkt pagina 9 van 42
■ 6
│
GB
│
CY
Setting up
For the safe and trouble-free operation of the
device, the set-up location must fulfil the follow-
ing requirements:
♦ Place the appliance on a firm, flat and level
surface.
♦ Position the appliance so that there is suffi-
cient space in front of and behind the lami-
nator. The laminating pouch should be able
to be fully inserted into the laminator and
ejected again without any problems.
♦ Do not operate the device in a hot, wet or
extremely damp environment or near flam-
mable materials.
♦ The mains power socket must be easily
accessible, so that the power cable can
be easily disconnected in the event of an
emergency.
Handling and use
Suitable laminating pouches
For hot lamination, you can use pouches with a
width of up to 320 mm and a maximum thick-
ness of 125 μm. Please note that each laminat-
ing pouch may only be used once.
Note
► For hot lamination, use only laminating
pouches that are expressly intended for hot
lamination.
► For cold lamination, use only laminating
pouches that are expressly intended for cold
lamination.
► Take note that the laminating pouches sup-
plied with the laminator are intended exclu-
sively for hot lamination.
Switching levels
Selector 2
Laminating pouch
thickness
80 MIC > 60–80
125 MIC 85–125
COLD up to 200
Note
► For high-gloss photos, you should choose
the setting 125 MIC as well as the corre-
sponding laminating pouch thickness.
Preparing for hot lamination
1) Insert the plug of the laminator into a mains
power socket.
2) Press the On/Off switch I/O w to switch
the appliance on. The LED COLD 6 lights
up.
3) Fold out the pouch support
e.
4) Press the selector switch 2 to set the
desired pouch thickness (80 MIC/
125 MIC) (also refer to the Switching
levels section). The corresponding
LED 80 MIC 7/125 MIC 8 flashes.
The laminator heats up to operating temper-
ature. Once the corresponding LED 80 MIC
7/125 MIC 8 lights up, the laminator
has reached the operating temperature.
Note
► The LED 80 MIC
7 or 125 MIC 8 lights
up to indicate that the operating tempera-
ture has been reached. For a more uniform
laminating result, we recommend first wait-
ing an additional 2–3 minutes before begin-
ning with lamination, especially for thinner
pouches (below 125 Micron) and after
adjustment to a different pouch thickness.
► The LED 80 MIC
7 or 125 MIC 8 may
occasionally turn off and light up again. This
means that the appliance is maintaining the
temperature and is reheating itself. This is
not a malfunction of the appliance!
IB_480151_2410_TLG400B2_LB6_CY.indb 6 31.01.2025 10:11:18
Bekijk gratis de handleiding van Tronic TLG 400 B2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tronic |
| Model | TLG 400 B2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3990 MB |
