Handleiding
Je bekijkt pagina 8 van 18
-7-
V. f - ADJUSTING THE SHELVES
Shelves and pins are shipped with the unit. First, select the
desired location and remove the white plastic covers in the
interior back and/or interior sides by rotating them. Install
pins in the new desired location (turn clockwise to tighten).
Make sure the pins are securely tightened. Slide the shelf on
the pins as shown below & secure it to the pins using nylon
tie-wraps. Replace the white plastic covers in the open holes
from where the pins were removed.
VI. CONTROL BASICS
Your new Centerline Refrigerator or Freezer is equipped with
a digital control, which precisely regulates operation. It is
supplied from the factory completely ready for use.
VI. a - INFORMATION MENU
The information available in this menu is:
* displayed only if enabled (see Conguration Parameters)
** displayed only if ACC > 0
Access to menu and information displayed:
• Press and immediately release button .
• With button or select the data to be displayed.
• Press button to display value.
• To exit from the menu, press button or wait for 10 seconds.
VI. a - INFORMATION MENU (cont’d)
Initiate Stand-By:
Keeping the button pressed for 3 seconds allows the
controller to be put on a standby or output control to be
resumed (with SB=YES only).
Locking the Keypad:
The keypad lock avoids undesired, potentially dangerous
operations, which might be attempted when the controller is
operating in a public place. In the INFO menu, set parameter
LOC = YES to inhibit all functions of the buttons. To resume
normal operation of keypad, adjust setting so that LOC = NO.
VI. b - ADJUSTING CABINET SETPOINT
Setpoint display and modication:
• Press button for atleast a half second to display the
setpoint value.
• While keeping the button pressed, use button
or to set the desired value (adjustment is within
the minimum SPL and the maximum SPH limit).
• When button is released, the new value is stored.
VI. c - INITIATING A DEFROST
Automatic defrost:
Defrost starts automatically as soon as the time set with
parameter DFT has elapsed.
• Timed defrost: With DFM = TIM defrosts take place at
regular intervals when the timer reaches the value of
DFT. For example, with DFM = TIM and DFT = 36, a
defrost will take place every 6 hours.
• Optimized defrost: With DFM = FRO the timer is only
increased when the conditions occur for frost to form
on the evaporator, until the time set with parameter
DFT is matched. If the evaporator works at 0°F, defrost
frequency depends on the thermal load and climatic
conditions. With setpoints much lower than 0°F, defrost
frequency mainly depends on the refrigerator operating
time.
• Defrost time count backup: At the power-up, if DFB =
YES, the defrost timer resumes the time count from
where it was left off before the power interruption. Vice
versa, with DFB = NO, the time count re-starts from 0.
In stand-by, the accumulated time count is frozen.
VI. CONTROL BASICS
Fig. 14
V. CARE AND MAINTENANCE (continued)
Bekijk gratis de handleiding van Traulsen CLBM-23F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Traulsen |
| Model | CLBM-23F |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 3673 MB |
