Tornado VCRMCWC handleiding
Handleiding
Je bekijkt pagina 18 van 115
English 18
Troubleshooting
If an error occurs while the robot is working, the indicator light of the robot or the auto-empty charging base will light up in
red in different states with corresponding prompt tones. Please solve it by the following table.
Indicator light Voice prompt Solution
Robot -
Flashing Red
Error 1: Front bumper stuck. Please
clean and retry.
- The front bumper is stuck. Please tap repeatedly to
remove any dirt. After confirmation, please relocate it to
start.
Error 2: Side brush stuck. Please
clean and retry.
- The side brush may be entangled with trapped dirt.
Please clean and retry.
Error 3: Roller brush stuck. Please
clean and retry.
- The roller brush may be entangled with trapped dirt.
Please clean the roller brush and retry.
Error 4: Wheel stuck. Please clean
and retry.
- The wheel may be entangled with trapped dirt. Please
clean the wheel and retry.
Error 6: Filter blocked or wet. Please
clean, dry and retry.
- The filter may be blocked or wet. Please clean it. If it is
not dry, please dry it for at least 24 hours. If it cannot be
solved, please replace the filter.
Error 7: Wheel suspended. Please
move it to near its original position
and retry.
- The robot may be picked up or suspended, please move
it to a new position close to the original position and retry.
Error 8: Cliff sensor dirty. Please clean
and retry.
- The robot is suspended in the air or the cliff sensor may
be stuck with dirt or blocked. Please wipe the cliff sensor
with a dry cloth and then move it to a nearby place to start.
Error 10: Device tilted. Please put the
robot on a flat surface to start.
- The robot is not on the level ground. Please put the robot
on the level ground and retry.
Error 11: Low Battery. The system is
about to shut down. Please charge it.
- The battery power is low (less than 5%) and it is not on
the charging base. Please place the robot on the charging
base to recharge.
Error 12: Robot trapped. Please clear
obstacles around.
- The robot may be stuck or trapped. Please clear
obstacles around the robot.
Error 13: Charging base blocked.
Please clear it.
- The area around the charging base may be blocked by
obstacles or dust. Please clean the area around and wipe
the charging base location beacon area.
Error 14: Charging error. Please wipe
the charging contacts.
- Please wipe the charging contact pins of the robot and
the charging contacts of the charging base with a dry cloth.
Error 15: Please insert the dust box
and filter.
- Please insert the dust box and filter, and confirm that they
are in place. If an error still occure, please try to replace
the filter.
Bekijk gratis de handleiding van Tornado VCRMCWC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tornado |
| Model | VCRMCWC |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 17004 MB |
